Send us a text

By providing your phone number, you consent to receive transactional/informational text messages (SMS) from Anderson Roofing, powered by Topline Pro. You can unsubscribe at any time by replying STOP. Message and data rates may apply. Message frequency varies.

By submitting this form, you agree to our Terms of Service & Privacy Policy.

Leak and roof repairs

Roof Leak Repair in Portland, OR

Anderson Roofing repairs leaks and roofs of every type on commercial, industrial and institutional buildings in Portland and Salem. We trace the water to its entry point first, then repair it so the fix lasts.

  • Since 1952
  • Oregon CCB #293
  • 24/7 emergency service
Metal roof flashing around a duct and a wall, taped off with blue tape
Finished white flashing at the base of a wall on a metal roof, with a roofer in a hi-vis vest at the edge
24/7

Emergency roof repairs. Crews in Portland and Salem.

Call (503) 294-0202

Why roofs leak

Where roof leaks actually start

Cross-section of a low-slope roof: water enters at the wall flashing, travels along the deck under the membrane, and shows up as a ceiling stain far from where it got in. WATER ENTERS TRAVELS ALONG THE DECK STAIN SHOWS UP HERE
Illustrative roof section, not to scale.

A roof leak rarely starts where the stain shows up. Water gets in at one point, travels along the deck or through the insulation, and drips from a ceiling tile somewhere else. That is why a minor issue left alone can turn into significant damage over time: wet insulation, a weakened deck and a repair area that keeps growing.

Repair work at Anderson Roofing tends to fall into a few groups: shingle replacement on worn slopes, flashing that was installed improperly, large repair areas that have outgrown a patch, and full roof restorations. Each one is a different repair, which is why the first job is finding exactly where the water gets in. Our Portland and Salem crews work on commercial, industrial and institutional roofs, locate the actual entry point, and repair it so the fix lasts. Catching a leak early is how a building owner saves time, stress and money later.

Leak map

Six places to look for a roof leak

A low-slope commercial roof has six details where water commonly gets in. Each number on the plan matches an entry in the key beneath it.

Plan view of a low-slope commercial roof with six numbered leak points: 1 flashing and terminations, 2 penetrations and curbs, 3 drains and scuppers, 4 seams and laps, 5 parapet and coping, 6 blistering and ponding. PLAN VIEW, NOT TO SCALE PENTHOUSE ROOFTOP UNIT CURB DRAIN SCUPPER PONDING 1 2 3 4 5 6
Simplified plan view of a low-slope commercial roof, not to scale. Your roof will differ, and we locate the actual leak before we repair it.
  1. 1

    Flashing and terminations

    Where the membrane turns up a wall, curb or edge, the seal depends on the flashing. If it was installed improperly, water enters at the termination.

  2. 2

    Penetrations and curbs

    Pipes, ducts, vents and equipment curbs all cut through the membrane. Each one is sealed with its own flashing detail.

  3. 3

    Drains and scuppers

    Drains and scuppers carry water off the roof. When one backs up, water sits and works at the nearest seam or flashing.

  4. 4

    Seams and laps

    Roofing sheets and plies join at seams and laps. A seam that has opened or lifted gives water a direct path into the roof system.

  5. 5

    Parapet and coping

    Water can enter through the coping cap, at its joints, or behind the wall flashing along a parapet.

  6. 6

    Blistering and ponding

    Blisters trap moisture in the membrane, and standing water wears on every lap and flashing it touches. Both point back to drainage and moisture.

Repair scope

What we repair

Anderson Roofing repairs every roofing type and accurately locates leaks, so the repair goes where the water actually gets in.

01Pipe penetrations through metal panels in two close-up views, one with a sealed metal flashing patch around the pipe

Flashing and metal detail

Failed flashing, edge metal and sealant details are rebuilt so the seal at each termination holds.

02Plywood roof deck exposed during repair, next to a finished shingle surface

Deck and substrate repair

Water that gets past the membrane can damage the deck or substrate below it. Those areas are opened, repaired and closed back up.

03White low-slope roof with a rooftop curb unit beside a metal-walled building

Penetration and curb detail

Pipes, ducts, vents and rooftop unit curbs are re-flashed and sealed with a detail built for each one.

04Brick chimney finished with new metal flashing and a metal cap

Chimney and cap work

Brick chimneys and masonry stacks get new metal flashing and caps where the old ones have let water in.

Not sure which of the six is yours? Tell us what you see and we will trace it.

Portland and Salem

Repair crews based in Portland and Salem

Repair work is only as good as the person tracing the leak. Our crews average 10 years with the company, and our foremen have 12 to 30 years in the field.

View down a brick wall from the roof edge to a blue boom lift and the street below
Blue boom lift working up the face of a downtown high-rise
1952

Founded in 1952, with fully equipped facilities in Portland and Salem.

CCB 293

Oregon CCB license, status active. No complaints in the past 10 years, on the Oregon CCB record. Open the CCB lookup

2006

Public Works bonded since 2006, which is why we can bid schools, campuses and public agencies.

A+

BBB Accredited since 2019 and rated A+. See the BBB profile

… I call them with any roofing needs. My roof is flat (I know, crazy for Oregon) and they can address any issues. The recent roof is a somewhat sloped design that has fixed all drainage challenges. …

Joyce Johnson - Google - Aug 2026

Service areas

  • Portland OR
  • Vancouver WA
  • Eugene OR
  • Salem OR
  • Gresham OR
  • Hillsboro OR
  • Beaverton OR
  • Bend OR
  • Springfield OR
  • Boise ID
  • San Jose CA
  • Seattle WA

Questions

Roof leak repair questions

How much does roof leak repair cost in Portland?

The cost of roof leak repair in Portland depends on what the repair involves. Fixing a single flashing detail takes less work than replacing a damaged section of deck or restoring a large area, and roof type, access and the size of the problem all change the price. Anderson Roofing offers free estimates, so request one and we will price the actual repair.

How do you find where a roof leak starts?

Anderson Roofing locates roof leaks in Portland and Salem by tracing the water back to its entry point, not by patching where the stain shows. On a commercial roof that means checking flashing and terminations, penetrations and curbs, drains and scuppers, seams and laps, and the parapet and coping. The repair is made once the entry point is confirmed.

Do you handle emergency roof leaks?

Yes. Anderson Roofing provides 24/7 emergency service, with crews working out of fully equipped facilities in Portland and Salem. Our office hours are Monday to Friday, 7:00am to 5:00pm, and emergency repairs are available outside those hours. Call the office number on this page to reach us.

Do you repair roofs outside Portland?

Yes. Anderson Roofing serves Portland, Vancouver WA, Eugene, Salem, Gresham, Hillsboro, Beaverton, Bend, Springfield, Boise, San Jose and Seattle. Tell us the building's location when you request a quote, and we will confirm how we can help. We repair every roofing type, including built-up, single-ply, metal, shingle, garden and paver roofs.

Tell us where the water is showing up

Request a free quote on the repair, or call for emergency service at any hour. Office hours are Monday to Friday, 7:00am to 5:00pm.